Page 1 of 1

Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 7:45 am
by Mojo
Hello, just started using Phoscyon new version 1.8.0. and experiencing few problems. In new version there's no more A = Gate, A#1 = Accent and B1 = Slide and I don't know how to apply Accent and Slide in FL Studio's piano roll now. Maybe anyone knows hot to and could help? Thank You!

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 8:39 am
by LiquidProj3ct
Accent: use PR's velocities (you can configure the threshold velocity in Phoscyon options)
Slide: just stack two notes

Best regards

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 9:12 am
by Mojo
Do you mean "Accent Velocity Level" settings:
Image
Or "Note velocity" levels in piano roll like I did them in this picture bellow:
Image
But actually when I change levels not much happening. All notes still sound the same. And about Slide: two overlapping notes produce slide effect only with FL Studios native synths as far as I remember from FL manual. Basically with this new version of Phoscyon I'm experiencing the same problems now like I had using Audiorealism's BassLine.

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 10:37 am
by LiquidProj3ct
Hi Mojo, you didn't notice any difference because all the notes velocities were greater than accent velocity level. With that setting, if you have a note velocity below 64 it won't be accented. As I can see in your picture you have all the notes velocities around ~100, so all of them are accented.

You don't need to use native fl studio slide notes, just overlap two normal notes and you'll hear phoscyon sliding.

Hope this helps ;)

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 10:54 am
by Mojo
Thanks for your reply LiquidProj3ct. How do you think which "Accent Velocity Level" option Low / Medium / High should I choose? I used to use a lot of accented notes in older Phoscyon version.

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 12:01 pm
by LiquidProj3ct
If you want a behaviour like to 1.6 select High. However I like Medium, because it's very easy know if the note is accented or it isn't. You can use very low and high velocity settings and see how FL Studio reflects it in note colours (darker of lighter green colour). Just personal taste, you can get the same results with all the values :wink:

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 2:01 pm
by Mojo
So basically if I choose Low (32) or Mid (64) or High (96) - all notes greater respectively that 32, 64, 96 velocity gonna be accented, isn't?

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 2:12 pm
by Sebastian@d16
Exactly :)

Re: Phoscyon pattern programing in piano roll FL Studio 9 help

Posted: Thu Feb 18, 2010 2:21 pm
by Mojo
Thank You both Sebastian and LiquidProj3ct :D