making a ph file

eeksta27 · Post by **eeksta27** » Thu May 28, 2009 9:54 am

does anybody no how to create a ph file?

Sebastian@d16 · Post by **Sebastian@d16** » Thu May 28, 2009 11:37 am

Hi,

If You use demo version, it's one of the limitations. You cannot either save or load patterns.

If You use full version, just use Patterns Load/Save buttons at the top of GUI.

Best regards,
Sebastian

eeksta27 · Post by **eeksta27** » Thu May 28, 2009 4:01 pm

Yeah i know how to load a pattern from the unit but i would like to save a ph file with a pattern in it.As i would like to try some of the patterns posted on the forum.

How do i do that?

Also how to i get the default pattern back as its changed?

Sebastian@d16 · Post by **Sebastian@d16** » Fri May 29, 2009 9:40 am

Hi,

If You own full version of Phoscyon (and You use VST of course, not an AU beta) save pattern button and load pattern button on GUI saves/loads whole bank of patterns into PH file. To replace only one of the patterns from the bank, You need to replace only one text block (representing pattern) in the .ph file, which is basically text based file. Just open it within any simple text editor.

Meaning of the content of .ph file can be found on this forum.

If You want to go back to factory bank just reload Phoscyon or:

1) save factory bank first,
2) make another copy,
3) do some changes in one file and keep another untouched,
4) if You're unsatified with the results just load the second file into Phoscyon (with original bank)

Best regards,
Sebastian